LEVER RELEASE PTO GUARD 

This durable PTO guard is designed for easy and safe operator use. Our range covers 95% of shafts currently available.

This durable PTO guard is designed for easy and safe operator use.  Our range of 2 guards covers 95% of shafts currently available.  You will find that connection of the shaft to the tractor is very much easier and maintenance of UJ and yoke is also easily achieved.

To operate press centre of red lever while lifting the ends, this will allow the guard to be retracted giving access to the yoke and retaining pin.  Returning the guards for use, ensure they are fully home and fitted to the bearing.  Pressing the centre of the red lever will allow it to lock back into place.  This should be checked by pulling back on the guard before use.

SAFETY Before approaching the PTO shaft ensure tractor engine is stopped and key removed Always ensure the guard is in good condition along all of its length and retaining chains are fitted

SMALL - fits A2+ A3 shaft 1500mm length suits A2 and A3 shafts Comes with clip on fastener to allow greasing of PTO coupling with guard in place. Comes with bearings to fit A2 and A3 and chain.
Suits all shafts with yoke groove 32mm to 53mm. Suits BYPY shafts up to 4 series, Hardy Spicer Shafts up to 1310 series, Walterscheid shafts up to W2100 Series, Jayben Shafts up to 4AG Series, U.S Shafts with above yoke groove diameters.

LARGE - fits A4 to A8 shaft 1500mm length suits A4 to A8. Complete with clip on fastener to allow greasing of PTO coupling with guard in place. Comes with bearings to fit A4 to A8 and chain.
Suits all shafts with yoke groove 53/60mm to 80mm. Suits BYPY shafts 5-6-7-8-9-10 series, Hardy Spicer Shafts 1350 series upwards, Walterscheid shafts W23 to W2600 Series.  Hardy Spicer Shafts 1350 Upwards.  Jayben Shafts 5AG Series Upwards.  US Shafts with above yoke groove diameters

Full Set of Bearings supplied with each shaft